kidzkasce.blogg.se - Motorola visar programming

#Motorola visar programming how to
#Motorola visar programming software
#Motorola visar programming series

Put your diode across the accessory connector, just remember to take your Want to do some hacking around you inside the radio you could rewire theĬoncentric switch so that instead of it being the keypad lock, have it If you open your radio and solder the diode inside the radio you will be able to program off the keypad BUT you CANNOT useĪ speaker mic (if you do it will be permanently keyed down). If you really want to program without a key there is a way, but it will void your warranty as well as create some other problems. Click here to see what is inside the JT1000 key. Motorola would like you to believe that the programming key is some hi-tech device, but as typical of Ma M, it isn't.

Program up the extra modes however you want and dump them into the radio.Īs you are probably aware if you are a JT1000 owner, to program your radio you either need to do it via RSS or have a programming key.

Remember to use the Add Mode Utility to add in the extra modes (up to 16).

When you load the file into RSS you will now be able to program up to 16 channels.

The value should be 0x01 for a 2 channels, 0x07 for 8 channels or 0x0F for 16 channels.

Ensure the editor is in overwrite mode, not insert.

The steps listed below detail what to edit.

Please only proceed if you are familiar with HEX editting!!! As well, you may want to keep a saved file in a different directory (then it will be easy to restore the radio to its original state). Norton disk editor or Hex Workshop will do the job. The next step requires a HEX editor which you will use to edit the saved file (code plug) from your radio. The easy part of the conversion to 16 channels is to remove the channel selector knob, if you remove the notch on the knob you will then be able to rotate it all 16 channels.

Then press enter to goto the next field, it willĪll Visars and JT1000's are 16 channels, if yours has less you need to enable them using RSS.

(add zeros until you've filled the field)

You must fill the entire field with characters.

You want (use the numbers along the top of the keyboard)

Hold down the SHIFT key while entering the frequency.

To get out of band frequencies follow the listed steps:

#Motorola visar programming software

Programming the radios outside of the bandsplit is very simple and requires no special software or hardware, all that is required is the standard Motorola RSS package (some versions may not allow the following thought). One such example would be the 450 to 520 split, with out of band programming you can use the radio in the 440 Mhz HAM band. Out of band programming can be quite useful.

#Motorola visar programming series

This series of radios generally performs quite well outside of the standard rated bandsplit. If you have the accessory adapter for the side connector on the radio, the typical schematic of the speaker mic looks like this.

#Motorola visar programming how to

How to convert 2 and 8 channel HT1000's to 16 channel radios How to program frequencies outside of the radios rated There is no provision in the radio's hardware or software to support any more than 16 channels.

WRONG! There is barely enough codeplug space to handle 16 channels with all the options, let alone any more. Yes, we know the display looks pretty, and that must surely make the rest of the radio capable of 99 channels. NOTE: In regards to the Visar's, there is NO way to make them have more than 16 channels. For this reason they are all contained in the same file. The above series of radios all use similar internal computer control boards and the same RSS package.